After the Reitz fan is turned on or used for a period of time, there will be some typical tripping phenomenon, which is more common for some fans, but the fan tripping phenomenon is mostly related to the fan's specification and installation specifications.
After the Reitz fan is turned on or used for a period of time, there will be some typical tripping phenomenon, which is more common for some fans, but most of the fan tripping phenomenon is related to the fan's specification and installation specifications, if we are using If you do not follow the fan's specifications, there will be more or less problems, and the trip will not be so unexpected. So how can we solve the trip problem? Below, Dongguan Ruitian Electromechanical "target=_blank> electromechanical technology will come to a simple analysis.
There are many reasons for the use of the Trips fan to trip. For example, when the fan starts up, the current is too large. The excessive current causes the fan to fail to start normally, or even fails to start. This is also a cause of tripping, because the fan belongs to High power, we recommend the use of step-down start-up for the Reitz fan, which can reduce the fan trip problem.
If the load of the Reitz centrifugal fan is relatively large, the regulating valve of the air inlet or outlet of the pipeline should be adjusted to the lowest position, so that the motor of the fan can be protected, the load of the fan can be reduced, and the frequency of the tripping phenomenon of the Leitz fan is It is relatively low. When the impeller rotates in the opposite direction, the correct rotation direction of the impeller should be adjusted in time; the incoming line is in poor contact or the same phase causes phase loss; the control box accessory has poor performance, or the line contact to the fan is poor, causing phase loss; the grid capacity is insufficient and the voltage is low. . The wiring of the line is leaky; the wiring is unreliable, after the operation for a period of time, the connection is broken due to heat; the motor wiring is wrong; the two-speed fan power "target=_blank> machine motor high-speed low-wire connection error; two-speed fan control box high and low speed number Inconsistent with the actual; the fan speed does not match too high. These reasons are caused by the circuit, so in the process of detecting the circuit must be solved one by one, so that the tripping problem of the Leiz fan can be solved very well. .
Http://news.chinawj.com.cn Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn
A2. Basin Faucet
kaiping aida sanitary ware technology co.,ltd , https://www.kpaidafaucets.com