How to solve the leakage problem from the production process of the rib

When the spacers are used, they are welded according to the distance between the spacers. Whether they are soldered to the crests or troughs of waves in the skirts is not considered. As shown in the figure above, most of them are welded on the crest, resulting in transportation of grain, gravel, silt, feed, etc., always causing a lot of materials to be transported back along the cracks in the trough, commonly called back materials, and sometimes carried. Many, and can not be unloaded clean, resulting in greatly reduced transmission rate. Moreover, the logistics followed the transportation, resulting in inaccurate traffic, cracks in the partitions, and materials at the peaks and valleys came back with each time, followed by a return, each time the amount is not small, can not calculate the correct delivery volume.

Qingdao Rubber Belt Co., Ltd. after research, the solution to this problem can be completely resolved in production. As shown below:

When we used separators, we placed each separator at the valley, which solved the problem of leakage and return.

In this production method, the partition must be cut in advance. The base of the foot should be short, and the cross-section of the partition should be slightly longer. It can just be embedded in the valley. This operation is time-consuming and laborious, and only the partition's labor time will be 3-5 times that of the normal partition. However, the work efficiency brought by it is immeasurable. The material could no longer be hidden in the valleys and crevices, but had to get off at the end of the battle. On the contrary, they are trapped in the valley, unless it is difficult to unload manually.

In this way, the problem of leakage of feed back was solved satisfactorily.