Traditional Yuba use and installation considerations
Traditional Yuba
Power wiring system should be standardized. The power of the traditional Yuba can reach more than 1100W. Therefore, the power wiring for installing the traditional Yuba must be a waterproof cable, preferably not less than 1mm of multi-filament copper core wire, all the power wiring must be set in the plastic pipe Within the wall, there must be no open-wire setting. The traditional Yuba power control switch must be equipped with a qualified product with a waterproof capacity of more than 10A. In particular, the old bathroom installation bathroom should pay attention to specifications.
The thickness of traditional Yuba should not be too thick. In the installation problem, we must pay attention to the thickness of Yuba can not be too thick when the purchase, generally about 20 cm on it. Because the traditional Yuba is to be installed on the roof, if you want to install the Yuba, you must add a top layer under the roof, that is, we often say that the plasterboard or PCV ceiling, so that the latter part of the Yuba can be caught in In the middle of the two, if Yuba is too thick, decoration is much more difficult.
Traditional Yuba should be installed in the center of the bathroom. Many homes install it above a bath or shower, so that the surface looks warmer in the winter but there are many security risks. Because infrared radiation lamps warm up quickly, it is easy to burn the body. The correct method should be to install the bathroom heater in the center of the bathroom top, or slightly close to the bathtub, so that it is safe and can maximize the function.
When traditional Yuba is working, it is best not to spray with water. Should pay special attention to the use of: Although the current bathroom heaters are waterproof, but in the actual use is best not to use water to splash, although Yuba waterproof bulb waterproof, but the metal parts of the body can not do this, That is, the metal in the body is still conductive. If it is splashed with water, it may cause a danger such as a short circuit to the power supply.
Avoid frequent switching and vibration around. Usually do not use the switch frequently Yuba, Yuba operation should not be surrounded by a larger vibration, otherwise it will affect the life of heating foam. If there is an abnormal situation during operation, it should be stopped immediately, and it must not be repaired and repaired on its own. It must be overhauled by the professional technicians of the after-sales service department.
It's best to keep the bathroom clean and dry. After bathing, do not switch off the bath immediately, and wait until the moisture in the bathroom is drained before shutting it down. Always keep the bathroom ventilated, clean and dry to increase the service life of the bath.
Yuba integrated ceiling ceiling bathroom switch interior decoration family decoration house decoration bathroom waterproof bathroom ceiling bathroom door
Metallographic Microscope ,Optical Microscope For Metallographic Observation,Inverted Metallographic Microscope,Portable Metallographic Microscope
Ningbo Beilun Kalinu Optoelectronic Technology Co.,Ltd , https://www.yxmicroscope.com