Three suites were installed to summarize the five details that the kitchen acceptance should pay attention to
The kitchen is a place for collecting water, electricity, and fire. It is also one of the key areas for home decoration. For the decoration construction, most of the owners have little knowledge and want to intervene. However, acceptance after the renovation of the kitchen must not be neglected. It must be done by hand. So, how to check the kitchen decoration?
Kitchen acceptance 1, kitchen ground
Kitchen uses a lot of water, oil, etc., so the kitchen must be laid non-slip tiles, and also pay attention to whether the floor of the anti-skid brick is not already laid smooth, but also pay attention to the difference between the wall and the ground is not coloring, laying The gap is not too large. In addition, the kitchen must be cleaned frequently during use. For convenience, it is necessary to see if there is any floor drain.
Kitchen acceptance 2, kitchen ceiling
The kitchen is best to use a full ceiling, because the kitchen smoke is relatively large, basically every month to clean once, so that when the acceptance of the kitchen to see if the ceiling is not solid, but also to see if the seams are not flat Place, to prevent the falling of the ceiling in the process of use, the drop of the ceiling will have a certain impact on human life.
Kitchen acceptance 3, kitchen ventilation
The ventilation window of the kitchen is very important, and the area can not be less than one-tenth of the kitchen use area, and the exhaust hole of the kitchen can not be less than 15 cm in diameter, otherwise the range hood is not installed, so say Both of these require the owner to measure it at the time of acceptance.
Kitchen acceptance 4, kitchen wall
Most households now use tile for the convenience of cleaning. The problems that can easily arise are chromatic aberration in tiles, large gaps in laying and so on. These problems are not fatal, though. , But it is very ugly, so say that these problems can only be discovered in time when the acceptance of workers in order to allow workers to rework.
Kitchen acceptance 5, kitchen utensils
Now that the kitchens are basically custom-made cabinets, then we can see if the cabinets of the cabinets have been deformed, the doors of the cabinets are not solid, the process of opening the doors is not very smooth, and so on. There is also the hardware. Smooth, low noise, no rust-free hardware is a qualified product. These small problems can only be found when the inspection is done. Otherwise, if the workers leave, they will certainly not return to you again.
Home decoration is a technical activity. Every detail in the construction process must be very careful. If the safety and quality are not enough, the best house is just a pretty dangerous product.
kitchen
N95 Respirator, Medical Mask, CE Kn95 Mask, Kn95 Mask Export
GUANGZHOU HTD INTERNATIONAL , https://www.maskhtd.com