1. According to the actual lighting needs of the installation site, determine the appropriate installation method (column top and lateral direction) of the luminaire, and adjust the mounting bracket. Then prepare the three-core cable of the corresponding length according to the distance from the luminaire to the power contact. 2. Open the buckle at the front end of the lamp by hand, open the upper cover of the lamp, and introduce the cable into the lamp cavity through the cable introduction hole at the rear of the lamp. Connect the cable according to the polarity indicated on the terminal block of the lamp. Connect to the "L" position, the neutral line is connected to the "N" position, and the ground wire is connected to the grounding position. After connecting the cable, press the cable to compress the cable.
3. Insert the light pole into the introduction hole of the mounting bracket, and select the appropriate position of the light pole in the bracket cylinder according to the angle required for lighting. Tighten the pressing bolt of the pressing light rod to connect the light pole and the light fixture firmly. .
4. When replacing the bulb, unscrew and pull out the lamp holder, unscrew the old bulb, replace it with a new one, and press the lamp holder with the appropriate gear position (400W bulb uses the outermost gear position, 250W lamp uses the innermost position) The gear position and the intermediate gear position are used for adjustment.) Push into the lamp cavity and tighten it.
5. Close the upper cover of the lamp and lock the buckle. Connect the three-core cable to the mains to realize the lighting.
Precautions
1. Fix the luminaire in the packaged carton when transporting to prevent breakage.
2. When using, the surface of the lamp has a certain temperature rise, which is a normal phenomenon; the center temperature of the transparent part is high and must not be touched.
3. When replacing the bulb, try to use the same type of bulb; if you change the bulb type or power, you should replace the matching ballast accordingly.
4. The luminaires are only used outdoors; the luminaires can only be used with a protective screen.
5. The cross-sectional area of ​​the external wiring should not be less than 1.5mm.
Optical Filter,Color Glass Filter,Colored Glass Bandpass Filter,Infrared Glass Filter
China Star Optics Technology Co.,Ltd. , https://www.realpoooptics.com