Carbon slab heating construction process
At present, as a new heating method, carbon crystal plate heating gradually enters people's lives. The carbon crystal plate heating is a heating plate made of a carbon fiber material as a heating element, and generates heat through far-infrared radiation, and the infrared rays have a certain health care effect on the human body.
construction
The following is the construction process of carbon crystal heating:
First, level the ground first, apply a reflective film on the concrete floor, and then apply a thermal insulation layer on the reflective film.
Second, the carbon crystal plate is laid in a set position, while leaving the outlet line tube, the wire is placed in the wiring tube, the line interface should use a special line tube connection, and put on a waterproof plastic tube, and then Hot air heater heat seal.
Thirdly, the ground pipe is re-enclosed with a PVC pipe, and a special glue is used between the PVC pipes for waterproofing.
Fourth, finally connect the thermostat switch on it.
The entire carbon crystal heating construction process can be completed in one day, and no more maintenance is required in the later period. The thermal efficiency of carbon crystal plates is relatively high, and the cost is not great.
Switch cement
Fold Flat Mask,Civil Protective Mask,Kn95 Filters Cup 3D Mask,Kn95 Filters Fold Flat Respirator
Ningbo Autrends Prevention Products Co., Ltd , https://www.autrendsafety.com